![]() ![]() It can be found in Core M ULV SoCs such as the Core M-5Y70. While the GPU shines with its extremely low power consumption, raw performance is quite low and barely sufficient for modern games.īroadwell features a GPU based on the Intel Gen8 architecture, which has been optimized in various aspects compared to the previous Gen7.5 (Haswell). This means the system will always wake from a low system power state when a USB device is connected to or disconnected from a root hub port if there is at least one device behind the UHCI controller that is armed for wake.The Intel HD Graphics 5300 (GT2) is an integrated Broadwell graphics card revealed in late 2014. Universal Host Controller Interface (UHCI) USB host controllers do not distinguish between remote wake signaling and connect change events on root hub ports. The USB hub driver arms a hub for remote wake-up only if the USB stack is configured to wake up the system on attach and detach (plug/unplug) events. If a USB leaf device on the bus is armed for wake, the USB stack will also arm the USB host controller for wake, but it will not necessarily arm any of the USB hubs upstream of the device. Wake-up behavior when attaching or detaching a USB deviceĪnother unique aspect of the USB implementation of the WDM power mode regards the arming of USB hubs for remote wake-up. The USB stack does not enable the device for remote wake-up when it receives a request to change the device to a sleep state of D3, because according to the WDM power model, devices in D3 cannot wake the system. When you design and debug your driver, you should keep in mind that there is a loose relationship between arming a USB device for wake-up in software, by means of a wait wake IRP, and arming the device for wake-up in hardware by setting the remote wake-up feature. ![]() Under most circumstances, when the USB stack receives this request, it both sets the remote wake-up feature on the device and puts the device to sleep by suspending the device's upstream port. Instead, it waits until it receives a IRP_MN_SET_POWER request to change the WDM device state of the device to D1/D2. The USB specification specifies that host software must set the remote wake-up feature on a device "only just prior" to putting the device to sleep.įor this reason, the USB stack does not set the DEVICE_REMOTE_WAKEUP feature on a device after receiving a wait wake IRP for the device. In USB terminology, a USB device is enabled for remote wake-up when its DEVICE_REMOTE_WAKEUP feature is set. The wait wake mechanism is described in the section Supporting Devices That Have Wake-Up Capabilities. Devices that are not capable of generating remote wake signaling include video cameras, mass storage devices, audio devices, and printers.ĭrivers for devices that support remote wake-up signaling must issue an IRP_MN_WAIT_WAKE IRP, also known as a wait wake IRP, to arm the device for remote wake-up. All of these devices are capable of producing remote wake signaling. Examples of devices that have a remote wake-up capability are mice, keyboards, USB hubs, modems (wake on ring), NICs, wake on cable insertion. ![]() ![]() USB devices that can respond to external wake signals while suspended are said to have a remote wake-up capability. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |